Clutch linkage of semi tips, to note here: ramp starts when the throttle than Ping Lu started, because in Ping Lu start engine only overcome resistance to motion of a vehicle itself, uphill but also overcome the ramp resistance, due to the resistance increased the engine power will increase accordingly, so the throttle to than Ping Lu started. Specific how much is appropriate, it depends on the size of the ramp, if the ramp is not too large, the throttle is appropriate on the line, if the slope is steep, then the throttle to get older, but the biggest is not more than the engine of medium speed. In short, the car clutch semi fixed point of the judge and the use of a principle is that in the beginning of the ramp, must keep the engine's power.
(1) as long as a clutch is carried to the semi coupling point, your feet don't lift the (if raise again, the engine will stall), don't jump to step on, if pressed down, the parking brake release, the car will be the next slide car. At that time, can release the parking brake, because at this time the friction clutch piece between the flywheel and pressure plate, both the transmission torque and slip, the reason at this point even if you don't pull the parking brake, engine cannot flameout, vehicles will not be the next slide, and it is for this reason. If you don't have to do this time to lift the parking brake, will cause the clutch friction plate to accelerate the wear and tear, and soon the clutch friction disc grinding bad or burning.
(2) vehicle starting (if the car does not move, a little more lift the clutch, the car began to go), after the start must be waiting for the bus before 5 meters above to the clutch pedal slowly all lift. Otherwise the engine will stall. |